X-Rite D19C Standard > D19C Full Upgrade Manuel de service télécharger pdf (Page 41)

Densitometric functions

............................

4.7

4.7 Print characteristic

........................................................................................................................................

Select automatic or manual filter selection under Settings k Color or in the selected

densitometric function under the menu line Color.

........................................................................................................................................

Enter the measurement parameters for the print characteristic under Settings k

Measurement parameters k Print characteristic.

........................................................................................................................................

Procedure:

• Select the menu line Print characteristic by turning the <Control ball>.

• Activate the selected function by pressing the <Measurement key>.

• Select the menu line Measure paper white by turning the <Control ball>.

• Position the measuring aperture on the paper white and initiate a measurement by pressing the

<Measurement key>.

• The display White measurement done is shown for about 1 second.

• Position the measuring aperture on the solid tone patch and initiate a measurement by pressing the

<Measurement key>.

• The density value of the solid tone patch is shown on the display.

• Position the measuring aperture on the halftone patches one after the other and initiate the

measurements by pressing the <Measurement key>.

• After the measurement of the 100% halftone patch, the menu line “Graphic mode” is shown in

reversed video.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 163 164

Pas de commentaire

X-Rite D19C Standard > D19C Full Upgrade Manuel de service Page 41