X-Rite D19C Standard > D19C Full Upgrade Manuel de service Page 64

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 164
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 63
Settings
............................
5.3 – 5.3.1
5.3 Jobs
........................................................................................................................................
For density difference measurements, it is necessary to measure or enter reference values.
Tolerance values can be overwritten. Four jobs with four to eight references each can be
defined. The names of the jobs can be freely selected. The names of the references one to
four are preset. The names of the references five to eight can be freely selected. Preset
default reference values and tolerance values may be set.
........................................................................................................................................
5.3.1 Job definition
Procedure if no job has been defined:
Select the menu line Jobs by turning the <Control ball> and confirm the selection by pressing the
<Measurement key>.
The display shows Define job in reverse video.
Activate the function by pressing the <Measurement key>.
Four job names are shown on the display.
Select the desired job by turning the <Control ball> and confirm the selection by pressing the
<Measurement key>.
The entry field of the current job name is shown in reverse video on the display.
Use the <Control ball> to select the menu line
oo
oo
o in the entry field.
Vue de la page 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 163 164

Commentaires sur ces manuels

Pas de commentaire